推拉棚是一種簡易小型篷房，可以遮陽擋雨，拆搭方便。除了日常停車使用，在國內外疫情形勢仍舊嚴峻的情況下，還可以用作防疫通道、核酸檢測棚等。下面來講講推拉棚的主架、立柱等部件的安裝事項。

The push-pull shed is a simple small tent, which can shade from the sun and rain, and is easy to dismantle and build. In addition to daily parking, it can also be used as an epidemic prevention channel and nucleic acid testing shed when the epidemic situation at home and abroad is still severe. Next, let's talk about the installation of the main frame, columns and other components of the sliding shed.

一、主架安裝:

1、 Main frame installation:

推拉棚主框架有兩種,一種是主框架分成兩半,另一種是主框架是一個整體,主框架是一個整體不需要忽略,那么就說主框架分成兩半以下內容:

There are two kinds of main frames of push-pull shed. One is that the main frame is divided into two parts, and the other is that the main frame is a whole. The main frame is a whole and does not need to be ignored. Then the main frame is divided into two parts, as follows:

查看主框架梁是否有剪式框架；沒有伸縮剪刀架,不需要注意；對于伸縮式剪式框架,有必要拼接半個主框架。拼接時應注意以下內容:主框架的半橫梁為螺釘,半橫梁為伸縮環。拼接時,一個主框架為半螺釘和半伸縮環；（注意以下內容:一個主框架不能全是螺釘,一個主框架全是伸縮環).在主框架拼接的中間,制造商將匹配用于固定的螺釘。

Check whether the main frame beam has a shear frame; There is no telescopic scissor frame, so you don't need to pay attention; For the telescopic shear frame, it is necessary to splice half of the main frame. Attention should be paid to the following when splicing: the half beam of the main frame is a screw, and the half beam is an expansion ring. When splicing, one main frame is half screw and half telescopic ring; (note the following: a main frame cannot be all screws, and a main frame is all telescopic rings). In the middle of the main frame splicing, the manufacturer will match the screws used for fixing.

二、立柱的安裝:

2、 Installation of columns:

當生產和制造推拉棚主框架部件時,我們將啟動立柱。一般來說,我們都有立柱。對于一些相對較長尺寸的產品,我們的立柱將被分開。這種連接更簡單。我們只需參照立柱前部的伸縮剪刀架的方向,后部是一樣的。完成后,我們將豎立立柱,每側各有一人扶著立柱。立柱將被豎立起來。第三個人需要找一根水平桿將主框架插入兩側的立柱中。

When producing and manufacturing the main frame components of the sliding shed, we will start the column. Generally speaking, we all have columns. For some products with relatively long sizes, our columns will be separated. This connection is simpler. We only need to refer to the direction of the telescopic scissors frame in the front of the column, and the rear is the same. After completion, we will erect the column, with one person on each side holding the column. The column will be erected. The third person needs to find a horizontal bar to insert the main frame into the columns on both sides.

三、頂部安裝:

3、 Top mount:

濟南推拉棚主框架和立柱已經安裝好,現在要穿上吊布。打開包裝好的頂部防水布,找出活動棚防水布的長度和寬度。登上山頂時,必須從左到右,而不是從前到后。一是要避免人員上頂時不注意,移動推拉雨棚前后傾斜,造成事故；二是要節省后期的人力和時間。頂棚布組裝完畢后,將立柱展開,從生產部滴膠到頂梁和橫梁上。如果有一塊布蓋住側面,不要先固定掛在側面的布。如果沒有布,立柱的上側裝有蝶形螺釘,用于固定頂部的懸掛棚布。

The main frame and columns of Jinan push-pull shed have been installed, and now we need to put on hanging cloth. Open the packed top waterproof cloth and find out the length and width of the waterproof cloth of the movable shed. When you climb the top of the mountain, you must go from left to right, not from front to back. First, it is necessary to avoid people not paying attention when climbing the roof, moving the push-pull canopy to tilt back and forth, causing accidents; The second is to save manpower and time in the later stage. After the ceiling cloth is assembled, unfold the column and drip glue from the production department to the roof beam and beam. If there is a cloth covering the side, do not fix the cloth hanging on the side first. If there is no cloth, butterfly screws are installed on the upper side of the column to fix the hanging shed cloth on the top.

四、固定安裝:

4、 Fixed installation:

現在整個移動推拉雨棚已經組裝好,雨棚在使用前固定,以延長移動推拉雨棚的使用壽命?；旧嫌袃煞N固定方式以下內容:一種是車輪固定。我們將匹配鏈條和頂部防爆螺釘,將車輪固定在地面上。另一種方法是拉動鋼絲繩,在活動遮棚前后四個方向固定一根繩子,以防止它被大風吹走。根據特殊性質,還有一些其他的固定裝置,也會有一些特殊的固定裝置。

Now the whole mobile push-pull canopy has been assembled and fixed before use to extend the service life of the mobile push-pull canopy. Basically, there are two fixing methods: one is wheel fixing. We will match the chain and the top explosion-proof screw to fix the wheel on the ground. Another method is to pull the steel wire rope and fix a rope in four directions before and after the movable canopy to prevent it from being blown away by the strong wind. According to the special nature, there are some other fixed devices, and there will also be some special fixed devices.

推拉棚拆搭便捷，隨搭隨用；其次與固定建筑相比，推拉棚更實惠；另外推拉棚作為一種簡易裝配式建筑，不需要復雜的審批手續，可以快速投入使用。您有選購的需求就來我們網站http://jyxingyu.com咨詢了解吧。

The sliding shed is easy to dismantle and erect, and can be used as soon as it is erected; Secondly, compared with fixed buildings, push-pull sheds are more affordable; In addition, as a simple prefabricated building, the push-pull shed can be put into use quickly without complicated approval procedures. Come to our website if you need to buy http://jyxingyu.com Consult and understand.